Monday, January 08, 2018

A Pattern For The Reverse Substitution Of Labor

Figure 1: Variation of Switch Points with Time
1.0 Introduction

This post presents another local pattern of co-dimension one. I have conjectured that only four types of local patterns of co-dimension one exist (a reswitching pattern, a three-technique pattern, a pattern across the wage axis, and a pattern over the axis for the rate of profits). In this conjecture, I meant to implicitly limit the rate of profits at which switch points occur to be non-negative and not exceeding the maximum rate of profits. The pattern illustrated in this post is a pattern around the rate of profits of -100 percent. (I was prompted to develop this example by an anonymous comment, as I was also prompted for this post.)

Although this is a local pattern, its interest comes from global effects. Suppose another switch point exists, other than the one at a rate of profits of -100 percent. This other switch point involves the same two techniques and occurs at a positive rate of profits. A perturbation of coefficients of production around the pattern changes the other switch point from one exhibiting a conventional substitution of labor to the reverse substitution of labor. Han and Schefold (2005) describe empirical examples of the reverse substition of labor.

2.0 Technology

Table 1 specifies the technology for this example. I make the usual assumptions. Each column lists inputs per unit output for each process. Each process exhibits constant returns to scale. Each process requires a year to complete, and there are no joint products. Inputs of capital goods are totally used up in production.

Table 1: Processes of Production
InputIron IndustryCorn Industry
AlphaBeta
Labor1 Person-Yr.9/100.994653826 et
Iron(7/10) Ton1/400.002444903 et
Corn2 Bushels1/100.746512055 et

In this example, technical change occurs in the Beta process for producing corn. I assume that σ is 1/10. So coefficients of production fall at a rate of ten percent.

At any moment of time, two techniques can be created out of these processes. The Alpha technique consists of the iron-producing process and the corn-producing process labeled Alpha. Likewise, the Beta technique consists of the iron-producing process and the corn-producing process labeled Beta.

3.0 Prices and Structural Economic Dynamics

I consider a common system for defining prices of production. Relative spot prices are assumed to be constant, and the same rate of profits is earned in both industries for the cost-minimizing technique. Labor power is advanced, and wages are paid out of the surplus product at the end of the year. For a technique that is not cost-minimizing, the costs for operating the corn-producing process in this technique, as evaluated at prices of production, exceed the revenues. I take a bushel corn as the numeraire.

These assumptions allow one to construct wage curves for each technique. The cost-minimizing technique at, say, a given rate of profits is found from the outer envelopes of the wage curves, that is, the wage frontier. Switch points arise at rate of profits for which both techniques are cost-minimizing. For this example, I do not present wage curves at selected moments of time. Figure 1 graphs the rate of profits at switch points and the maximum rate of profits against time. Patterns, including a pattern for the reverse substitution of labor, are indicated on the graph.

3.1 A Superficial Neoclassical Story

Suppose one limits one's analysis to non-negative rates of profits. Figure 1 shows that technical progress leads to a switch point at the maximum rate of profits. As the wage curve for the Beta technique continues to move outward, this switch point falls below the maximum rate of profits. For rate of profits lower than at the switch point, the Alpha technique is cost-minimizing. The Beta technique is cost-minimizing at higher rates of profits. Eventually, the switch point disappears across the wage axis, and only the Beta technique is cost-minimizing.

This story initially seems to correspond to exploded neoclassical intuition about technical change. Reswitching and capital-reversing - two phenomena much emphasized in the Cambridge Capital Controversy - never occur. Around the switch point with a positive rate of profits, the Beta technique is cost-minimizing at a notionally smaller wage, and the Alpha technique is cost-minimizing at a notionally higher wage. A lower wage is associated with a technique in which greater labor inputs, aggregated across both industries, are employed per bushel of corn produced net.

3.2 A Region in which the Reverse Substitution of Labor Occurs

But consider what happens when the analysis is extended to a rate of profits of -100 percent. A switch point with a positive rate of profits exists only for time between the patterns over the axis for the rate of profits and across the wage axis. Figure 2 graphs the difference in the labor coefficients with time. After the pattern for the reverse substitution of labor, the labor coefficient for the Alpha process in producing corn exceeds the labor coefficient for the Beta process in producing corn. That is, around the switch point, the adoption of the cost-minimizing technique at a lower wage results in less labor being employed in corn production per unit corn produced gross. How is this consistent with the textbook account of labor demand functions?

Figure 2: Change in Labor Input per Unit Gross Output in Corn
4.0 Conclusion

The more I investigate price theory, the less I understand how economists can teach neoclassical microeconomics.

4 comments:

Sturai said...

Would it be the r<0 a recession?

Robert Vienneau said...

I don't think so. Prices of production do not surprise the capitalists. I think recessions are tied to unfulfilled expectations.

Switch points with negative rates of profits greater than or equal than -100 percent can tell us something about switch points with positive rates of profits. I think my point is an analytical one.

Sturai said...

Can you tie the "recurrence" effect pointed by the last works form Steedman and Opocher to this biffurcations (patterns)?
I am thinking about your graphs representing inputs recurrences.

Robert Vienneau said...

Maybe, but I would need to think about it.

As I understand Opocher and Steedman's 2016 MetroEconomica article, they are concentrating on recurrence of processes among techniques. My pattern analysis diagrams show where different sort of switch points between techniques appear and disappear from the wage frontier. The labels for techniques (Alpha, Beta, Gamma, ...) and their wage curves do not indicate which techniques have processes in common.

So I would have to supplement my diagrams with more information. I have been thinking I should try applying my pattern analysis to a more complicated example, with more produced commodities and more techniques. This example has process recurrence and is thus a candidate for such work.